14 pin Panasonic cell phone special connector at the mobile phone (keypad up)
This page documents the 14-pin connector used by the third-party data cable for the Panasonic G60, X100, and X500 mobile phones. The connector layout is specific to these handset models. Only the pins utilised by the cable are listed below.
| Pin | Signal | Description |
|---|---|---|
| 14 | DLPWR | Remote Power ON (IN) |
| 13 | Tx_IrDA | Transmit Data (OUT) |
| 12 | SDO | Data Out (OUT) |
| 11 | Rx_IrDA | Receive Data (OUT) |
| 10 | CTS_MODEM/SDI | CTS / Data IN (IN) |
| 9 | RX_MODEM | Receive Data (IN) |
| 8 | TX_MODEM | Transmit Data (OUT) |
| 7 | RTS_MODEM/nSCS1 | RTS / Chip select1 (OUT) |
| 6 | DSR_MODEM | DSR (IN) |
| 5 | DTR_MODEM | TPU in WATE Mode (IN) |
| 4 | ACC_PWR | Power Supply (IN) |
| 3 | VACCID | Analog Input (IN) |
| 2 | SCLK | Serial Clock (OUT) |
| 1 | DGND | Power Supply and Digital GROUND (GND) |
Notes
Pin numbers refer to the connector on the handset; pins not listed are unused by the cable.
References
- Panasonic EB-G60 Service Manual (OMTD030301C8) — External I/O Connector (§7.5.1) — Panasonic Mobile Communications.